Q Light Controller+

Hello,
I would like to run a lighting with QLC + through a network whose topology is attached. I use a eDMXKing interface.
When I use QLC + from the same subnet it works.
But when I'm on a different subnet it doesn't works.
With Wireshark, I see that the Artnet frames are broadcast, certainly blocked by the first router. How can I do to make it works?
Thank you in advance for your help !
Best regards !
Christian

Use a 4.10.0 test version:
viewtopic.php?f=5&t=8962

It allows entering an arbitrary ArtNet output IP

I will try tomorrow.
Thanks Massimo !

Hello Massimo,
Indeed, with the 4.8.3 version it was impossible to address the interface outside the subnet. With version 4.9.1 it is possible to set the last byte of the address, even if the interface is on another subnet, and with version 4.10 it is possible to fully define the address.
With my 3 old routers reaction time is quite slow, but it works.
Thank you for your answer, and for that software evolution.
Best regards.
Christian