QLC+ and Artnet with subnets

Archive of the non-categorized posts related to the QLC+ technical support.
Please do not create new threads here, instead, use the categories above !
Post Reply
christianhor
Posts: 5
Joined: Mon Oct 05, 2015 5:44 pm
Real Name:

Hello,
I would like to run a lighting with QLC + through a network whose topology is attached. I use a eDMXKing interface.
When I use QLC + from the same subnet it works.
But when I'm on a different subnet it doesn't works.
With Wireshark, I see that the Artnet frames are broadcast, certainly blocked by the first router. How can I do to make it works?
Thank you in advance for your help !
Best regards !
Christian
Image
Image
Image
Top
User avatar
mcallegari
Posts: 4827
Joined: Sun Apr 12, 2015 9:09 am
Location: Italy
Real Name: Massimo Callegari
Contact:
Contact mcallegari

Use a 4.10.0 test version:
viewtopic.php?f=5&t=8962

It allows entering an arbitrary ArtNet output IP
Top
christianhor
Posts: 5
Joined: Mon Oct 05, 2015 5:44 pm
Real Name:

I will try tomorrow.
Thanks Massimo !
Top
christianhor
Posts: 5
Joined: Mon Oct 05, 2015 5:44 pm
Real Name:

Hello Massimo,
Indeed, with the 4.8.3 version it was impossible to address the interface outside the subnet. With version 4.9.1 it is possible to set the last byte of the address, even if the interface is on another subnet, and with version 4.10 it is possible to fully define the address.
With my 3 old routers reaction time is quite slow, but it works.
Thank you for your answer, and for that software evolution.
Best regards.
Christian
Image
Top
Post Reply

Return to “Archive - no new threads please”