Page 1 of 1

Problem sending output to Dimmerpack

Posted: Fri Sep 18, 2015 10:39 am
by Cyclus
Hi Guys,

Iam new here and for the first time using QLC. I bought a Enttec open DMX USB so i could control DMX as wel as my Dimmerpack Zero88. I've been watching over 2 hour of tutorials everywhere and made the first step to control lights with QLC+. However i did everything what all the tutorials said and when iam ready to control my lights nothing happens.

I connected my Enttec in the output screen to universe 1. Its also says its working perfectly.
I made general fixtures of 28 channels.
I made a scene with the first 4 channels as they are my Front lights.
I activated them.
And at least i made a virtual console with a few buttons redirected them to the scene.

When i press play and activate those buttons nothing happen. Not even in the function tab with scene's when i program them.

Extra info: Using a MacbookPro version 10.10.5 Yosemite and i restarted my Macbook afther installing.

Re: Problem sending output to Dimmerpack

Posted: Fri Sep 18, 2015 12:40 pm
by mcallegari
Hi, please read the documentation too, cause this is a very well known problem discussed like a million times in this forum.
You need to disable the Apple FTDI native driver.

See here
http://www.qlcplus.org/docs/dmxusbplugin.html
Note for OSX users: If your adapter is detected but doesn't produce any output, most likely you'll find the solution in the Questions and Answers page.