[Compatibility] Behringer CMD-LC1
Posted: Wed May 13, 2015 4:41 am
I am a newbie to QLC+ (I was a QLC user) and I have just purchased a Behringer CMD-LC1 but having some issue with it.
1. Encoder (Knob) - I cannot get it to work properly, it would appear that it doesn't send the absolute value when turned (only sending turn up / down)
2. LED Feedback via MIDI -it utilises a different set of code for driving the LED states. (e.g. Multi button 1 uses 97 20 XX, Multi button 2 uses 97 21 XX, XX being the LED setting: 00 = Amber Solid, 01 = Green Solid, 02 = Green Blinking...etc) Am I missing some setting somewhere or QLC+ currently does not support it?
Attached is the Input Profile, MIDI Profile (for testing LEDs) for CMD-LC1
Link to MIDI map: http://www.behringer.com/assets/CMD_LC-1_MAP.pdf
Thanks in advance
Jands
1. Encoder (Knob) - I cannot get it to work properly, it would appear that it doesn't send the absolute value when turned (only sending turn up / down)
2. LED Feedback via MIDI -it utilises a different set of code for driving the LED states. (e.g. Multi button 1 uses 97 20 XX, Multi button 2 uses 97 21 XX, XX being the LED setting: 00 = Amber Solid, 01 = Green Solid, 02 = Green Blinking...etc) Am I missing some setting somewhere or QLC+ currently does not support it?
Attached is the Input Profile, MIDI Profile (for testing LEDs) for CMD-LC1
Link to MIDI map: http://www.behringer.com/assets/CMD_LC-1_MAP.pdf
Thanks in advance
Jands