Midi input Auto-detection OK but Playback fails in Virtual Console
Posted: Sun Nov 09, 2014 10:30 am
Hello Massimo,
The behavior is the following:
softwares:
- Loopmidi (used since a long time with previous releases of QLC+)
- QLC+ 4.8.2
- sendmidi.exe binary file with argument --out 1 --program-change 0 10
in virtual console, when using Auto-detection, QLC+ identifies well the signal and display value 395.
I also declared a MIDI profil and the signal is well catched by the wizard.
Going to playback mode, no button can be activated in Virtual Console, despite the Input/output editor identifies the signal and display the arrow way signal received on midi port.
The Midi port is declared Open.
I am using a qxw file migrated from previous version of QLC+
Is it a known issue or do I have to create a new qxw file ?
Regards
Alain
The behavior is the following:
softwares:
- Loopmidi (used since a long time with previous releases of QLC+)
- QLC+ 4.8.2
- sendmidi.exe binary file with argument --out 1 --program-change 0 10
in virtual console, when using Auto-detection, QLC+ identifies well the signal and display value 395.
I also declared a MIDI profil and the signal is well catched by the wizard.
Going to playback mode, no button can be activated in Virtual Console, despite the Input/output editor identifies the signal and display the arrow way signal received on midi port.
The Midi port is declared Open.
I am using a qxw file migrated from previous version of QLC+
Is it a known issue or do I have to create a new qxw file ?
Regards
Alain