Timer in chase loosing control
Posted: Tue Sep 30, 2014 8:51 pm
Hi,
QLC 4.7.4 (OSX 10.9.5)
I created several scenes and put them into a chase. I then started the chase and it was way too fast as the timer was at 0 for duration. I adjusted the duration and then the chase would run normal on the last 4 parts but just quickly through the 1st 2 parts.
All durations were set the same, adjust duration, fade-in or fade-out had no affect on them.
I saved my workspace, close QLC and re-opened my workspace and the chase worked correctly.
If there is anything I can capture for you in that instance please let me know.
Thanks
Jimmy
QLC 4.7.4 (OSX 10.9.5)
I created several scenes and put them into a chase. I then started the chase and it was way too fast as the timer was at 0 for duration. I adjusted the duration and then the chase would run normal on the last 4 parts but just quickly through the 1st 2 parts.
All durations were set the same, adjust duration, fade-in or fade-out had no affect on them.
I saved my workspace, close QLC and re-opened my workspace and the chase worked correctly.
If there is anything I can capture for you in that instance please let me know.
Thanks
Jimmy
