Q Light Controller+

Surely if the flashes are in a solo frame, only one should be possible a time. Using it to flash LED fixtures and it creates a colour mix effect, which I don't want.

hello there Joe

not sure how you have your scenes set up.. i would first of all be sure all your scenes are set up right such as intensity and fade times. The flashes respond to fade as well. They are just a momentary on function rather than a toggle, and if one of the flash scenes overlaps that of an adjacent one it will also light up. If its instant on/off your looking for make sure your scene's fade times are set to .0 sec or it will cause mixing as it approaches your max set value.

i set up multiple scenes in a solo frame and then create an "All Chase" button outside the solo. I have found that while all chase is running i can select one of the scenes in the solo simultaneously, because the all chase is not in the solo it works independent of actually selecting a soloed scene. Not a flaw just part of QLC's logic

I've created a bunch of scenes that use the RGB channels to create the colour, and then they have the dimmer turned up for the flash. I then put them all inside a solo frame. IMO this is a flaw in the logic, as if i wanted to be able to flash multiple at once, i'd put then in a normal frame rather than a solo frame. This makes it harder, as I have to hit the right keys at exactly the right time and make sure there's 0 overlap, but also try and keep the gap between colours as short as possible.

ok see what your sayin... Not sure what would cause that.. my solo frames don't do that. I run scenes and fixture programs in solo and that doesn't happen even when cueing with midi..only when running a chaser of those soloed buttons outside the solo frame can i cause that to occur..