Q Light Controller+

Hi All.

Had test system working and adding more controls, scenes and all. Now when I load the project it crashes QLC and drops back to the prompt.

HDMI output shows QLC restarting after the project is loaded then it drops out.

Is there a log that I can look at for QLC that will show if there file has an issues or something QLC does not like?

It's hard to see on the video I captured but looks like:

ftdi_sio 1-1.2:1.0; device disconnected

The web interface in non-resonsive, SSH into the Rpi I can get around but if I try to perform RESTART is sits for a moment and comes back to prompt and does not reboot and restart.

Thanks for any help.

I attached my project file

Hello Jimmy, you just spotted a generic crash, not specifically related to the RPi.
I tested your project via web on the desktop version and it crashes as well.
Gonna fix it right away.

Thanks

OK, I've fixed it.
It was something related to nested multipage/non-multipage frames.

Will be included in version 4.8.2

Thanks Massimo,

I also seen if I load the a single page project about 3 or 4 times in the web it will crash it as well. Could that be part of the same issue?

I attached the file I was using.