Q Light Controller+

Hello

As stated in the topic title. While building a show I added 2 chasers which include a sequence each. They simply pulse par lights for rear of the stage and front of the stage. Rear red, front white.

When playing the show they become "paused/freeze/stuck". I created a new show (Test Show) and rule out the issue but the same thing still happens.

Further Issue scaled down.

You included all your 4in1's in both sequences, so when you try to run them both at the same time they fight against each other.
I quickly added 2 buttons on your VC to mimick the outcome. Check the DMX monitor and you'll see.
Solution: delete the fixtures which are not focused in both sequences.

Morning

Thank you so much for taking the time to find the issue. This morning I replicated the setup to try and solve it and could not find a reason even while examining the XML show file.

I "cloned" the sequence trying to be faster instead of creating a new one from the menu. This resulted in both sequences bound so when I changed one it changed the other.

TLDR: Don't clone the sequence, create a fresh new one.