Q Light Controller+

Hi everyone
A FRIEND ASKED ME TO CREATE SOME FIXTURES FOR HIM.
THEY WERE CREATED FROM MY COMPUTER, I TAKE THE FILES TO YOUR COMPUTER BUT THEY DID NOT WORK
IT TAKES ME ALL AS A SINGLE CHANNEL DIMMER.
YOU COULD TRY IF IT WORKS???

These definitions are not complete. You have created channels, but defined no modes for any of these fixtures.

The QLC manual has a section on using the fixture editor and covers the process of creating a fixture definition well enough, IMO.

The front page has a link to the fixture validator where you can upload your definition and see if it's done correctly.

Finally, what advantage does writing in CAPS gain you, may I ask? It looks ugly and is received as aggressive shouting by most people...