Page 1 of 1

Image will not autostart / checksum fail

Posted: Tue Oct 01, 2019 5:07 pm
by buldar
I've flashed the image provided at least 10 different times and each time my pi will boot into command line but not auto start. i read in another post this may be due to a corrupt image file. so i downloaded the .md5 file to check and got this error on several different downloads on 2 different computers.

Checksum comparison report generated by ExactFile version 1.0.0.15
10/1/2019 9:03:27 AM

Digest file: C:\Users\ajgillette\Downloads\qlcplus_raspbian_buster_20190825.7z.md5
Base folder: C:\Users\ajgillette\Downloads\

1 files in digest file. 1 errors.

FAIL SHA1 qlcplus_raspbian_buster_20190825.7z

Please, help..

Re: Image will not autostart / checksum fail

Posted: Wed Oct 02, 2019 6:47 am
by mcallegari
Checksum is MD5, not SHA1.
Also, have you plugged something on the HDMI port?

Re: Image will not autostart / checksum fail

Posted: Thu Oct 03, 2019 7:51 am
by Dingezz
found out that the latest buster release doesn't start the QLC webinterface without a monitor attached, checked it on the pi 2, 3 and 4 the previous stretch version works fine without monitor. (RPI 4 not supported)

Re: Image will not autostart / checksum fail

Posted: Thu Oct 03, 2019 8:07 am
by mcallegari
I suspected that.
Then see this: viewtopic.php?f=7&t=13738 (solution on page 2)