Where is LTP/HTP set?

[bssmusic]

Hello,
I have the following problem:
I urgently need all channels being LTP, because if I call up for example a scene by button, I want the faders on the virtual desk to follow and show the result. Unfortunately either only the dimmer channels or all intensity channels ( don't know why one or the other case) are reset to HTP, when I load the setup, although I have saved it with all channels set LTP. The result is, that I can't raise any fader, which is represented on another page of the VD. Does anybody know, where and how I can make the LTP behaviour permanent?
Version is 4.10.3a Windows
test1.qxw attached as example

Thanks in advance
Peter

[yokosuna]

Go to the devices tab, press the fith button on the second row (mouse over should say something like "channel-fader properties"),
expand the node you need to and there you are...
HTH

[bssmusic]

No, unfortunately this is NOT the solution:
Of course I can change the behaviour here, but when I save the setup, the next time I load it, all dimmer- brightness- color-channels are set HTP again.
This is, why I asked for a permanent change!
I suspected this in the fixture editor, but there is no possibility either.
@ programmers: Is it possible, that this part is not saved by any reason????
Peter

[yokosuna]

Hi, I tried that too: made a workspace, added four dimmers, changed all but the third from HTP to LTP, saved it, quit QLC.
Loaded the workspace again - all dimmers were restored as expected...must be another issue in your settings.

Edit: I tried that with your workspace and can confirm that something weird is going on - settings are saved by random.
I think you should post it under ISSUES and let the developers jump in ....

[janosvitok]

Peter,

can you post your custom QXF files?

Jano

[bssmusic]

Hallo Jano,
here they are...

Good idea to post it in issues

Peter

Fixtures_custom.zip

(20.52 KiB) Downloaded 92 times