external ip device causes qlc to stop on windows
Posted: Sat Apr 23, 2016 10:37 am
Had/have a weird one...
Qlc 4.10.3a on windows (and linux)
No workspace loaded.
Using a Trancension sdc-6 as input. (This is a simple dmx 6ch controller).
Enttec usb mk2
Windows Vista.
Input profile copied from linux, but Qlc/windows still stopped when no ip-profile loaded.
With Enttec conected to usb and with dmx cable connected but no device(sdc6) connected , qlc runs fine. ie it stays working and doesn't stop.
Connect the sdc6 to dmx cable, but not switched on, Qlc runs fine.
Switch the sdc6 on, 3-5 secs Qlc stops, ie windows says qlc has stopped responding.
All the equipment and Qlc works ok with linux. Just windoze...
Any ideas pls?
Qlc 4.10.3a on windows (and linux)
No workspace loaded.
Using a Trancension sdc-6 as input. (This is a simple dmx 6ch controller).
Enttec usb mk2
Windows Vista.
Input profile copied from linux, but Qlc/windows still stopped when no ip-profile loaded.
With Enttec conected to usb and with dmx cable connected but no device(sdc6) connected , qlc runs fine. ie it stays working and doesn't stop.
Connect the sdc6 to dmx cable, but not switched on, Qlc runs fine.
Switch the sdc6 on, 3-5 secs Qlc stops, ie windows says qlc has stopped responding.
All the equipment and Qlc works ok with linux. Just windoze...
Any ideas pls?