Q Light Controller+

Ok,

i have attached the (minimalistic) project.
Just go to VC and follow the written steps. but all in all:


Buttons which are activated by loopback , work on page 1 of a frame but not on other pages. When you open the settings and just press ok they will work again until you switch to page 1 and than again to page 2.


Using 10.3a MAC OS X el Captain 10.11.4

if its only with me: thats what happens when i use it:

http://jasperzevering.de/qb.mov

Same Behavior with Windows 10 and 4.10.3a

I checked the workspace and I can reproduce the problem. I'd need to check the sources where is the problem and I don't promise I will check it