Page 1 of 1

How to assign fixtures to the same address

Posted: Fri Apr 01, 2016 6:57 am
by yokosuna
Hi, I want two fixtures to have the same DMX address - how can I achieve this ?
Thank you.

Re: How to assign fixtures to the same address

Posted: Fri Apr 01, 2016 6:57 am
by Flo
yokosuna wrote:Hi, I want two fixtures to have the same DMX address - how can I achieve this ?
Thank you.
Just set the (physical) fixtures to the same DMX address. There is no need (and no possibility) to create the fixture two or more times in QLC+ because it is not possible to set the fixtures to different values if they share the same address. If you want to make it more clearly that the one fixture in QLC+ represents two or more physical devices just rename it (e. g. "LED PAR (x6)").

Re: How to assign fixtures to the same address

Posted: Fri Apr 01, 2016 7:44 am
by yokosuna
Thank you and I see your point.
Why do I ask this question ? Well, I thought about using the "threshold" in the dimmer curve to
use it with EFX to achieve some dimmer toggle effects that are in sync with movements....
Maybe I need to look at the "loopback" feature....