Page 1 of 1
How to start a cue when no sound is detected
Posted: Thu Mar 31, 2016 11:48 pm
by yokosuna
Hi, I tried to set the activate threshold to 0% (actually, lesser than 5% is not allowed)
and the deactivate threshold to 25%. But that did not work.
Any ideas ? Thank you.
Re: How to start a cue when no sound is detected
Posted: Fri Apr 01, 2016 3:48 pm
by siegmund
Hi,
are you actually able to see the sound bars moving in the widget? Don't forget to enable it.
Re: How to start a cue when no sound is detected
Posted: Fri Apr 01, 2016 4:20 pm
by yokosuna
Sure, perhaps I can take a look at the sourcecode to figure out what´s going on inside.
For the moment, it looks like qlc+ ist swapping upper/lower values of the threshold if lower > upper.....