Q Light Controller+

Hey everyone.

I'm trying to setup the Enttec Playback Wing, and running into an issue.

I map the "Go" and "Back" buttons to a Cue List. When you press them, a lot of the time it will count it as a double input, (i.e.: it skips one step each time.)

I've also tried mapping other buttons, and it does the same behavior.

EDIT: The double input is on the Mac version, running OSX 10.11.3. It doesn't do this behavior under a virtual Windows 7 instance on the same Mac.


Any ideas? Is it better to run the Playback Wing in ArtNet mode?

Thanks!

Two years later and this behavior is still a problem. I'm having the same issue.