Q Light Controller+

BTW I love this software it works well for me in the past few years! Ok I have 6 (6 channel) LED pars (generic). I want to be able to set it up in the "Virtual Console" so I can adjust the strobe speed with either a "tabp button" OR a "slider". Now the dmx channels are as follows:

CH1 Dimmer
CH2 Red
CH3 Green
CH4 Blue
CH5 Program/Strobe
CH6 Program/Strobe speed

I have already have a scene set up the pars where the dimmier is 100% as is the RGB (to make white) and CH5 is set to "strobe". All channels are check marked (active).

How can I accomplish the ability to adjust strobe speed on the fly?

Thanks in advance for your help.

You should be able to just use a slider controlling the Strobe speed channel.

I don't have an idea to do it with a tap button at the moment. The only possibility would be to use flashing scenes instead of the strobe ability of your fixture, but this solution would extremely limit the maximum speed of the strobe.

Thanks I figured it out tho. Now if I can get my Korg Nano Pad to work with it that would be great!

siegmund wrote:You should be able to just use a slider controlling the Strobe speed channel.

I don't have an idea to do it with a tap button at the moment. The only possibility would be to use flashing scenes instead of the strobe ability of your fixture, but this solution would extremely limit the maximum speed of the strobe.