Q Light Controller+

Hi,

Yesterday i installed the qlc plus Programm on my Raspberry Pi 2.
Everything worked as expected and the Pi 2 started with Qlc+ in Fullscreen.
But there are no fixtures available. Even not the generic one. And i dont have the possibility to make a new file.
The button is greyed out.
Did i make a failure on the Setup ?

What i want to do is to get my Setup already done on my MacBook with Qlc + there to work.

So how to do that. Is the Way over the webfrontend the only one ?
In which path are the fixtures stored on the Pi 2 ?
Can i move my files from the Mac directly to the Pi 2 ?

Best Greetings

Nils

Please take some time to read the user guide PDF.
QLC+ on the Raspberry Pi starts by default in operate mode.

So how to do that. Is the Way over the webfrontend the only one ?

You can upload custom fixtures via web. Read the PDF

In which path are the fixtures stored on the Pi 2 ?

You should not copy fixtures manually. In any case they're in

Can i move my files from the Mac directly to the Pi 2 ?

There's SSH access. Read the PDF

Thank you. I already read the manual before i wrote my questions. But i think i have to do once more.

Hello Massimo,

i get it to work now.

i think the main problem is to get the first connection to the system.
Therefore i found that thread very helpful: viewtopic.php?f=7&t=1817#p8983

Maybe you can pin it in the forum, or include this text to the manual.

Best greetings

Nils