I am just starting with QLC+ and slowly building my experience and controls. I am working towards a new lighting system for a village hall in Scotland.
I have a limited fixture control operating. I am currently practising with a MacBook air and i-phone 6. I plan eventually to use a Raspberry Pi.
I am controlling a Stairville RGBW flood in 8 channel mode using a fixture definition I wrote myself.
I have successfully got a virtual console working. This controls 8 channels on a single fixture. I then added control by TouchOSC from an i-phone using OSC. I got two channels working. I then created a larger profile controlling all 8 channels. Now when trying to control by OSC the levels leap about but do not follow the faders. All channels are set as absolute values and have a range of 0-255. I temporarily had this problem with one fader working in 2 channels. I fiddled with the widget properties and this 2 channel set up started working again. Unfortunately I cannot replicate this with the 8 channels now behaving oddly.
Up until now I have got round every problem I have had, but this has defeated me.
I have attached the qxw file.
If I am being daft I apologise, but would appreciate being told what I am doing wrong.
Mike
TouchOSC control
-
Tannahill
- Posts: 6
- Joined: Fri Dec 04, 2015 9:52 am
- Location: Dunblane, Scotland
- Real Name: Mike Price
- Attachments
-
Flood Test.qxw- (8.66 KiB) Downloaded 55 times
-
Tannahill
- Posts: 6
- Joined: Fri Dec 04, 2015 9:52 am
- Location: Dunblane, Scotland
- Real Name: Mike Price
I appear to have resolved the problem. I think I was incorrectly creating the template in Touch OSC editor. Sliders had a value range of 0-255. Should be 0-1. Had I looked at the already working templates, e.g. Mix 16, I would have known better.
Thanks to all those who read the post. Apologies for time wasting.
Mike
Thanks to all those who read the post. Apologies for time wasting.
Mike