Page 1 of 1
problem pairing numark orbit controller
Posted: Tue Jan 12, 2016 5:01 pm
by madmonkey
Hi there! I'm having a little difficulty pairing my orbit with qlc. I've got it mapped correctly, but I can't get a midi signal from channel pad banks 2-4. Pad Bank 1 registers fine. Could anyone help?
Re: problem pairing numark orbit controller
Posted: Tue Jan 12, 2016 5:09 pm
by janosvitok
Without checking orbit protocol: Is it possible that the banks send values on different MIDI channels?
If so, open MIDI plugin settings and select omni mode (1-16).
See
http://qlcplus.org/docs/midiplugin.html
Re: problem pairing numark orbit controller
Posted: Tue Jan 12, 2016 7:24 pm
by madmonkey
I don't see the Omni choice. I'm missing something.
Re: problem pairing numark orbit controller
Posted: Tue Jan 12, 2016 7:41 pm
by plugz
It's stated in the doc:
MIDI Channel: This is the channel where QLC+ will receive or send data through the MIDI system. MIDI channels can go from 1 to 16. The special "1-16" channel will tell QLC+ to receive or send data on any MIDI channel.
1-16 should appear when clicking here (see screenshot).
Re: problem pairing numark orbit controller
Posted: Tue Jan 12, 2016 7:44 pm
by madmonkey
Found it! Thanks! Works perfect now! I have it linked through midiox, and running serato at the same time. I use Serato on pad 1, and the lights on 2-4.