Page 1 of 1
Osc bridge and overscan issues
Posted: Thu Dec 17, 2015 4:24 am
by Sqeegie
I have 4.10.2a on OS X El Capitan and whenever I load a show and go from virtual console to simple desk the entire app overscans my 13" screen and have to continually move the app around to get to the channels as well as go into operating mode. Is there a way to fix this?
The other issue I am having is I am using touch Osc bridge and am connected to my MacBook Pro, I cannot seem to get any inputs to read. It used to work prior to El Capitan a long while ago but now I can't. What am I doing wrong?
Re: Osc bridge and overscan issues
Posted: Thu Dec 17, 2015 9:35 am
by mcallegari
First, please use 4.10.2b. It includes some more fixes than 4.10.2a
Secondly, what you ask has already been discussed several times in this forum.
See this:
viewtopic.php?f=5&t=8846
Do you see the blinking joystick in the Input Output panel when transmitting OSC data ?
Re: Osc bridge and overscan issues
Posted: Thu Dec 17, 2015 5:50 pm
by Sqeegie
mcallegari wrote:First, please use 4.10.2b. It includes some more fixes than 4.10.2a
Secondly, what you ask has already been discussed several times in this forum.
See this:
viewtopic.php?f=5&t=8846
Do you see the blinking joystick in the Input Output panel when transmitting OSC data ?
Thank you! As for the OSC, I do not see a joystick in the output panel.
Re: Osc bridge and overscan issues
Posted: Thu Dec 17, 2015 5:50 pm
by mcallegari
Sqeegie wrote:Thank you! As for the OSC, I do not see a joystick in the output panel.
Then the QLC+ OSC plugin is not configured properly. Check the IP address and the port
Re: Osc bridge and overscan issues
Posted: Thu Dec 17, 2015 5:50 pm
by Sqeegie
mcallegari wrote:Sqeegie wrote:Thank you! As for the OSC, I do not see a joystick in the output panel.
Then the QLC+ OSC plugin is not configured properly. Check the IP address and the port
Ok, I will double check again. And that goes with using the TouchOSC bridge too. I haven't been able to get that to work either on it.