Q Light Controller+

I just upgraded to resolume 5.0 and it offers dmx out via artnet (to display video on a rgb pixel panel) my current setup is universe 5-8 is a 20 by 25 pixel panel ran by e1.31 to a pix light 16 controller, Windows 7

Is there away to map artnet in to the rgb panel through Qlc?

Hello,

Krsound wrote:I just upgraded to resolume 5.0 and it offers dmx out via artnet (to display video on a rgb pixel panel)

I've tested this, it's nice

Krsound wrote:my current setup is universe 5-8 is a 20 by 25 pixel panel ran by e1.31 to a pix light 16 controller, Windows 7

You mean you have a windows 7 computer, and QLC+ runs on this computer ? And you have a 20x25 RGB panel ? And this panel is patched to universes 5-8 in QLC+ ? And the output plugin you use to send info to this panel is E1.31 ?

Krsound wrote:Is there away to map artnet in to the rgb panel through Qlc?

Yes, it's possible. The most simple way is setting the 5-8 universes in Passthrough mode, and their input to ArtNet. Does QLC+ run on the same computer as resolume ? This may be an issue, I have to test this case.

I would love Qlc+ to be able to do video to RGB panel natively.

I have played with the image animation, but again this is a bit of a faff as there is no automatic re-size.

There is away to make qlc do video matrix pixels after what plugz told me earlier today you can setup a free program call jinx and map your channels of videos or what ever and run it through a pass through universe in qlc, I was going to suggest for the creators to look into a jinx plug in but after some research on the jinx site it's not a open source software or a development download so there is not a way to embed it.