Q Light Controller+

Has anybody done a profile yet?
http://www.americandj.eu/en/ricochet.html

YES! I'll post it tomorrow.

Cheers Boxy.

Might have to create myself one now though, need one for tonight.

I did most of it today then the fixture editor crashed so went back half an hour. You can create a quick temporary definition for it easily though.

I just got one delivered today

I just started to do a one myself and guess what it crashed about half way through also

boxy wrote: I did most of it today then the fixture editor crashed so went back half an hour. You can create a quick temporary definition for it easily though.

:/ Do you happen to remember what you did to make it crash ?

plugz wrote:

boxy wrote: I did most of it today then the fixture editor crashed so went back half an hour. You can create a quick temporary definition for it easily though.

:/ Do you happen to remember what you did to make it crash ?

I was just inputting the values for one of the DMX channels, and i went to advance onto the next channel then it just hung for a few seconds then crashed.
I was doing it on my mac with latest Yosemite o/s.

It was the known issue with range restriction of used values. Typically, if editing a channel's ranges rather than starting afresh, (from 0 to 255), things can go wrong. I think i said before it would be nice to be able to freely change values then have a validation process before OKing the channel ie. rather than prevent input, flag clashing values.

If I ever manage to install qlc from source I'll look into things. I have a load of ideas for streamlining the editor but c++ is hard enough without qt being on top of it

Last attempt looked for qlcconfig.h which didn't exist.

One Ricochet.

boxy wrote:One Ricochet.

Nice one.

Boxy, have you managed to create any decent scenes using the ricochet?
I like a lot of the shows already in the unit itself, but can't recreate anything like those ones myself.
I just wish ADJ put the shows into a DMX accessible channel.

I know