Q Light Controller+

Hello!
I have used Midi inputs to control QLC+ before (I see there is even Midi Beat Clock Support for syncing), but can I use QLC+ to send out START and STOP messages to the MIDI output? What about Midi note messages or Program Changes or NRPNs? I know this is not music creation software nor a midi sequencer, but being able to send out some midi control messages would be nice. Sorry if I missed it. Thanks!!

frenchy (Steve French)
www.voltvision.com

Note on and pc output is possible. Select output on a midi line, in the settings select either note or pc mode. Channel is either note number or pc number (i.e. the table for midi input is not valid). This is an inconsistency that may be fixed in later versions.