Q Light Controller+

Hi everybody,
I am trying to configure QLC with my akai apc mini to control my fixtures. I wonder if some of you have a solution to my problem. I'd use a fader as encoder. Let me explain: Into virtual console, I would select my fixtures via buttons and then use a fader to graduate selected fixtures.
Do you think this is feasible ?

I hope to read you soon.
Ben

Hi, I think you can do it by using:
- Frame/Solo Frame
- Buttons
- Slider in submaster mode

My interpretation of what the OP is asking for might be a little different. I was thinking they were asking for the ability to use a fader to control relative intensity instead of absolute intensity. For example:

• Fixture1 @ 50%, Fixture2 @ 0%, Fixture3 @ 75%
• Select the buttons for Fixtures 1 & 2
• Move "encoder" up 25%
• Fixture1 @ 75%, Fixture2 @ 25%, Fixture3 @ 75%

Unless I'm misunderstanding the original post.

I've also done something similar to what Massimo is suggesting in order to control multiple channels independently from a single physical fader. Except I used the Frame Enables instead of buttons & a Submaster. See the attached workspace.