Q Light Controller+

I am new to QLC and still going through tutorials. I have to have my fixtures with many addresses between them because until I am up to speed with QLC, I am using my Chauvet Obey 70, which demands addresses be preset. The Obey will also be my backup once I learn QLC. So my simple desk has inconvenient access because I must scroll pages to get to the sliders of every fixture but my first one.

I have been searching for this tidbit of info in the videos and the manual but drawing up a blank. Before I spend all this time researching this issue, I'd like to know at least if it's possible, and if so, how it can be done.

thank you so much for your patience.

Scotty

Hi,

http://qlcplus.org/docs/simpledesk.html

An icon description is "Switch the view mode from all channels to fixture channels. Please note that if no fixtures has been defined, the second mode will produce an empty result"

This should be what you're looking for.

Yes, oh thank you! The icon is "View Mode". I was barking up the wrong tree, trying to eliminate the channels some more difficult route, I guess. No wonder I couldn't find it.

Thanks again.