Q Light Controller+

I would appreciate this fixture. For some reason when I create the fixture, it resets back to a generic blank when I load it into a workspace.

Thanks

Try this

http://www.chauvetlighting.com/products ... byX_UM.pdf

Thank you! I created a fixture definition according to the manual twice but was only getting one channel to go through. I must have missed something.

Thanks again

DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer.
1) Set dipswitches position to DMX mode.
Mode DIP switches
DMX 10= On
2) Use DIP switches 1-9 to set the DMX address.