Q Light Controller+

Hi I'm new to this so bare with me

I want to create an LED matrix panel out of ws2811 LED strips. In total I will have 192 RGB LEDs which is too many for one DMX Universe.
Can I create the panel in QLC+ to run as whole but split across two DMX Universes?
I shall be using a Raspberry PI 2 to run the show via ARTNET to an ARTNET to DMX unit. The LED strips are controller from a small PCB that converts DMX to WS2811.

Hope that makes sense.

If you try to create panel e.g. 16x12, QLC+ will split it automatically.
If your strips have the universe split in a different place, you have to create them separately, and then manually add pixels from the second one to the first.