Q Light Controller+

Hallo zusammen,

es gibt zur Zeit eine Kleinigkeit, die mich richtig nervt. Der Dimmer-Wert geht automatisch auf 255, wenn ich einen Effekt starte. Kann man das abstellen? Wenn nicht, wäre dieses ein Vorschlag von meiner Seite.

Gruß,
mps

_________________

Hello,

There is currently a little thing that annoys me. The dimmer value will automatically set to 255 when I start an effect. Can I stop this? If not, this would be a suggestion for the next software-version.

Regards,
mps

It's been there since 2011 (since original QLC): Check online help for EFX Editor, or directly here: http://qlcplus.org/docs/efxeditor.html#efx-intensity

EFX Intensity

When EFX is started, it will set the intensity of all included fixtures to the preset value. That usually means it set them full on. If you don't want this, just set the preset intensity to something lower, perhaps 0. That way you can control intensity of the fixture using other means like VC sliders for the intensity/dimmer channels, or by another chaser.