Q Light Controller+

When you have a Slider or Knob in VC in Level model and e.g. set low limit to 250 and high limit to 255 - and then assign a knob on a Midi controller... Then the "range" of the knob on the midi-controller is still 0-255 and not 250-255 .. This makes it impossible "hit" specific DMX values - e.g. "252" as it is on a very narrow range on the knob instead of 1/5 of the knob

Any workarounds ?

Unfortunately there is no workaround on a released version.
I just fixed it, so unless you compile from sources, you need to wait for the next release
Thanks for spotting this out.

Thanks Massimo .. Just sent you a small donation in appreciation..Will have to wait to next release as I have no clue how to compile... Any Idea when next release will be out ??

Hobgob, thank you very much for the donation !
I hope I can release a new version before the end of the month, but this is not a promise