Q Light Controller+

Animation is a think that i love. Permit me to do a big job in few seconds.
But i have problem with the starlight mini wash led that born with inverted rgb (at 0 valute they do all power and at 255 they do black) so colors are not what i am expeting.
I tryed by channel modifier to invert without success.
Any suggest?

I`m using last bit version.

Hi Tolmino, are you sure you can't set some inverted mode directly from the device menu ? (if it has any)

Otherwise I would say channels modifiers should work. Just remember to apply them to all the 3 RGB components.

Tolmino, can you attach the qxw file here (also with any fixture definitions that are not standard in the QLC+)?

The device affected is that one:
http://sourceforge.net/p/qlcplus/discus ... /b52d1798/

As you can see, massimo, there is only a mode. And i haven't Any menu to invert RGB way.

Jano, i have the PC with qxw file blocked in a fly-case tetris on a truck. Can you do a test by looking DMX monitor values difference between a RGB device and that one that is affected?

Thanks in advance.


(Before start animation in virtual console, i must open shutter of those wash devices)

Invert channel modifiers seems to be working.
Please share your workspace file when you get your hands on it.

Hi, I attach here the workspace with channel modifiers inverted for RGB Values, and attach a video too, that show that isn't working.
Excuse me for delay.