Page 1 of 1
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 12:36 am
by Dean Clough
QLC+ 4.8.2 On A Mac.
I'm trying to create a new profile for a LEDJ Par 56 can. But to no avail.
although its a 4 channel fixture, each time i create one, it only comes up with one channel.
http://prolight.co.uk/images/media/LEDJ ... 31-um0.pdf
any tips?
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 9:46 am
by Massimo Callegari
If you share the fixture definition maybe.......................
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 1:40 pm
by Boxy
Crappy manual didn't list power consumption
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 6:39 pm
by Dean Clough
Boxy, thanks for that one.
I just had a look against the one i done, and looks like i got it completely wrong, mine was not saving anything and when it was it was only on one channel.
Thanks.
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 9:51 pm
by Tavon Markov
Gotta remember to build in the Mode tab... all of the different channel configs..
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 10:38 pm
by Dean Clough
I'm currently stuck on my other one now, i know these are basic steps to set up but i'm finding it really hard.
Ive got a DMX decoder which is one of those decoder to RGB strip lighting types, now the unit itself is only a 3 channel unit each controlling one channel of 0-256 values, but can't figure it out. ;-(
What Am I Doing Wrong
Posted: Wed Dec 10, 2014 10:51 pm
by Dean Clough
With a bit of trial and error, and keep looking at some of the tutorials i'm making some progress
What Am I Doing Wrong
Posted: Thu Dec 11, 2014 8:26 am
by Boxy
There are tutorial videos on utube that should explain most of it. QLC+ is very much a layered program in that the 'things' you do are built up with the basics first. In case of the fixture editor, channels then modes etc. You must give everything a name at the top too.