Q Light Controller+

Hi, i have installed the git release.
after last update i can set input on peperoni interfaces.
according to Jan Menzel (peperoni's engineer) that interface can use input and output together.

i attach a debug file, where can be visible that if i use interface only in output, it works correctly (i have used simple desk to move lights)

the issue i have is when i try to use it in input.....
i have associed an input dmx channel to a button.... and when i try to do the same for another button, leds on interface blink differently (reb blinking RC-DMX one become black first and after some minutes green); qlcplus is like freezed (in 4 or 5 seconds i can re-have control...) and interface stop to send new dmx signals.

thanks in advance

After last git update i have a more stable qlcplus
it isn't blocking like before !!

dmx input has worked for half hour

after that it has stopped to work.
i attach a debug file where is visible that messages:
PeperoniDevice "USBDMX" failed control write: Connection timed out
PeperoniDevice "USBDMX" failed to read receiver startcode: Connection timed out

when peperoni interfaces has blocked, for close qlcplus i have need more than 5 seconds (after click on close)

thanks

Excuse me, but now i have more informations about that interface still:

it don't block .... if i wait some time (that can be 3 seconds to 15-20) it restart to work

when it freezes i have USB blinking led that stop blink and is on.
interface restart when led start bink .

in debug i don't see nothing because i think that i need to see usb debug!!