Q Light Controller+

it may be that the channels of simple deck respond to a MIDI signal?

I have a Elation Midicon an if i press one of the buttons 1 to 32. The faders on simple deck goes full on. Button one have a midi channel of 182, fader 182 in simple desk goes full on. Button 2 have a midi channel of 183, fader 183 goes full on.. and so on.

Today i have searching for The problem and i cant find iT.

You can control Simple DESK channels with channel groups.
http://www.qlcplus.org/docs/channelsgroupeditor.html

There is no way to do a 1-to-1 assignment of channels from an external controller

Hi Massimo,

The problem is not that i want to use simple desk with my Midiocon. The problem is that my Midicon now activate faders (full on) on simple desk. I want to deactivate that.

Then I don't understand the problem.
Simple Desk is normally just a monitor. If you don't touch it manually, it just displays the current values of the DMX channels.

I go to find out what the problem is.. i let you know if i find out.

I don't no whats wrong.

When i checked the input for midicon without checked the Enttecusb open there is no problem. When i checked both there is a problem.

The problem is that your MIDIcon input is mapped to your DMX universe.
The input (=MIDIcon) and DMX (=open DMX) universes must be different.

For e.g. universe 1, map output to your DMX device
For e.g. universe 2, map input and feedback to MIDIcon device.

Otherwise MIDIcon data will show up on your DMX output, and that's also what Simple Desk is showing.

Thank you very much!!