Q Light Controller+

Hi,
I just would like to know if it's an hardware issue and in case what controller you can suggest, I'm using a nanokontroll2 - I'm aware I can't pretend much from it - but it's impossible for me to fade manually a cue list, I've tried both the 1 and 2 sliders options: when I reach around the middle of the slider movement the output levels become suddenly very low, the effect it's like to pass almost thruogh a black before reacing the 2nd cue.
Is it be possible to adjust the curve of the cross-fade?
I'd like to know how it works for you, thanks.

A kind request for the developers...

I've found out why it's not possible to fade manually a cue list with a simple test, just 1 dimmer from 50% to Full, 2 cues:
- in timed mode it's correct and the output change between these 2 values;
- in the manual mode the output goes down till the 2nd cue reaches the level of the 1st one;
on the stage this means a temporary under lowering of the lighting that it's not tolerable.
I've tried to adjust it manually but it's out of my ability, especially thinking of a full show.
Today I had the occasion to test it with 2 professional consoles and the behavior it's as espected, using a single or double manual Xfade.
Probably not much people care about this but personally I'm looking for the possibily to play manually a cue list.
I'd appreciate an answer and anyway thanks for all your work.

Noticed the same. First I thought: shitty dimmers. But they where ok. Have some time tomorrow in the theatre to check it.

Offtools

This is related to this issue: https://sourceforge.net/p/qlcplus/discu ... /d6f0ed17/ and https://github.com/mcallegari/qlcplus/issues/439

Thanks for the pointer