Page 1 of 1
Using an APC 80
Posted: Thu Feb 12, 2015 12:14 pm
by Ian Alvarez
Is there any way to map an APC 80 to q light? An APC 80 is a an APC 20 and APC 40 that are physically connect but still separate in software. Essentially I want to know if there is a way to run both at the same time? My understanding so far is that you can only run one device at a time. Is that true?
Using an APC 80
Posted: Thu Feb 12, 2015 11:36 pm
by Maikel Boerebach
I don't see why that wouldn't work, since both the 20 and 40 are already pre-configured in QLC.
It should work without any problems.
Using an APC 80
Posted: Fri Feb 13, 2015 1:40 am
by Ian Alvarez
You can use them simultaneously in the same universe?
Using an APC 80
Posted: Fri Feb 13, 2015 10:02 am
by david garyga
Hi,
They will have to appear in two different universes, as you can't have two inputs in one universe.
But this is not an issue.
An input in universe 43 can control functions that affect fixtures in universe 1.
Everything should work out-of-the-box
