Page 1 of 1
blackout not doing intensity channels only
Posted: Sat Feb 07, 2015 7:30 am
by lcslouis
the blackout button only does all channels. would it be possible to make it do intensity channels as well configurable as the grand master.
Also i would like to see is the ability to have stop all functions and a blackout button on the same button.
blackout not doing intensity channels only
Posted: Sat Feb 07, 2015 12:50 pm
by dmxWolf
If I understand what you want to do, just make a function with only your intensity channels activated and set at 0, then put it on a button in a separate solo frame. To stop all functions and blackout at the same time, I make a button for each and assign the same hot key to both buttons. I use ESC to trigger both at the same time.
Note: You may have to have at least 1 intensity channel set to 1 to get the button to latch and stay on, otherwise it will act similar to a flash button.
blackout not doing intensity channels only
Posted: Sat Feb 07, 2015 3:00 pm
by lcslouis
I know i can do it I've been using qlc+ since it was qlc. What I am saying is it would be better to make it where you could set it. And having a dual stop all and blackout would be good as well cause unless your using a external controller or the keyboard triggering more than 1 button at a time is not possible.