Q Light Controller+

I am using an AKAI APC40 for midi input into QLC+.

When i try to add the channels in the profile editor, for the main sliders and the pad matrix, only the first control works. For example, there is a row of 8 sliders. QLC+ will only recognize the first slider. It will also only recognize the first pad of the matrix. However, all the knobs, the master fader, and all the scene launch buttons are recognized.

I know its not a problem with the APC40 because Traktor recognizes every control.

Please Help!!!!
Thank you

Try to enable multichannel mode in MIDI plugin settings. See http://www.qlcplus.org/docs/midiplugin.html, section configuration.

MIDI Channel: This is the channel where QLC+ will receive or send data through the MIDI system. MIDI channels can go from 1 to 16. The special "1-16" channel will tell QLC+ to receive or send data on any MIDI channel.