Q Light Controller+

I'm playing with a MIDI stream from Mixxx and have problem with cue lists. If I define a cue list and define the 'Next cue' to come frm an external input (MIDI in my case), then cue list automatically starts itself on the first input and, when I manually stop it it starts itself again on the next input. It is impossible to stop the cue list if input is still coming.

In a short test this is the case too, when 'next cue' is assigned to a key.

How can I define a cue list which I can activate or deactivate, depending on my needs ?

IIRC put the cuelist in a frame. Frames have enable button (the green check). If the frame is not enabled, it doesn't accept external input.

Yes, that works perfectly fine.

I struggled a bit to put the cue list into the frame because the 'Add' item is hiding in plan sight at the bottom of the frame menu.

You can use ctrl-c / ctrl-x / ctrl-v in the virtual console, to move your cuelist in a frame.

Also, when you select a frame, these (see screenshot) buttons will add a component in the selected frame.

PS: http://www.qlcplus.org/docs/index.html

Thanks.

In general I find QLCplus very easy to use. Things are laid out quite clear and simple. But some things are not immediately visually obvious, this is not a problem, just the nature of humans to overlook thigs.