Hello gentlemen. Im doing my first baby steps into QLC+ and light programming.
Here is my setup:
EEEpc 1000h
Win 7
QLC+
ENTTEC ODE
Korg NANOKontrol2
1x Chauvet SlimPAR HEX 3 IRC
I got everything up and running. I can run scenes with slider it in virtual console but
I was wondering..
Can I program the fixture in my scene using the NanoKontrol2
It seem to me that im not getting everything out of the controler
it is set for input in the input\output tab and checked for feedback.
Thanks a lot in advance!! Looking forward to this and find a good workflow.
and let me know if i missed the topic in the forum or in the manual
Hello.. Should I be able to program the fixture in my scene using the NanoKontrol2??
-
david garyga
Hi,
I think what you are looking for is:
http://www.qlcplus.org/docs/vcslider.html
Section "External input"
Auto Detect: When toggled, you can just move/press a button/slider/knob on your external input hardware and it will be automatically assigned to the slider. The latest combination is shown on the text boxes when QLC+ receives input data. If you don't see anything in the boxes, your input connection might have a problem that you need to fix first.
I think what you are looking for is:
http://www.qlcplus.org/docs/vcslider.html
Section "External input"
Auto Detect: When toggled, you can just move/press a button/slider/knob on your external input hardware and it will be automatically assigned to the slider. The latest combination is shown on the text boxes when QLC+ receives input data. If you don't see anything in the boxes, your input connection might have a problem that you need to fix first.
-
Simon Carignan
Thanks David for answering me. Im out and about for the weekend ill give it a try asap next week