Q Light Controller+

Hello,

I was so excited to realize that video playback was a feature of QLC+. I'm still learning about QLC+, but I've come a long way. My question is specifically about the Video function.

When I assign a video Output Screen from the function properties, it seems to ignore my selection and just play in screen 1. (I have three screen on my system). So, if I assign screen 2, it will still initial play on screen 1. When I preview the selection for the second time, it will in fact play on the appropriate screen 2, as selected.

I would suspect that if no one else is having this issue, it's my fault, as I'm using a 560ti Card, along with the integrated intel video out of the cpu. It works just wonderful with other programs, but I realize that it could be the source of confusion.

Any info would be helpful.

Thanks,

Stephen

Setup Info:

QLC+ 4.8.1

Windows 7 Ultimate 64 bit
i7 16GB Ram/SSD Drive/560ti Video card/Intel Integrated Video

Hello Grumpka, I checked this and it's confirmed on Windows.
On Linux it works perfectly.
I guess this is another cross-compatibility bug of the new Qt5 framework

I'll dig into it and see if I can come up with a workaround.
Thanks for reporting

Hi Massimo, Thank you for looking into this. No worries, as the work around is very simple. I just have to trigger each video function once, prior to a show. The next time the same function is triggered, it will output properly. That may be helpful for others as a quick fix. Honestly, I'm very grateful to have the video function. It's been a lot of fun.

Kind Regards,

Grumpka

Post removed. I felt my question was to confusing and not related to this thread. Sorry.
~Grumpka