Q Light Controller+

Is there a reason I can not get a workspace to automatically load on startup?

Id like to setup Qlight in a bar environment so that all a bartender has to do is turn on the computer. With Qlight put into the startup of windows, I'd like to automatically start light scenes with no interaction. Can this be done?

Yes this is possible, have a look at command line parameters in the manual

OMG, I looked everywhere... Thanks. Helped.

For those running Windows, create a shortcut and Add the following to the target of the shortcut.

--open "name of workspace".qxw

OMG, I looked everywhere... Thanks. Helped.

For those running Windows, create a shortcut and Add the following to the target of the shortcut.

--open "name of workspace".qxw

If you add the -k switch it will start in kiosk mode, with only the virtual console visible and locked in operate mode.