Values not recorded in Show Editor
Posted: Thu Jun 26, 2014 10:44 am
Hi.
I'm on 8th track. I created 3 sequences that have 1 simple step each
Each sequence uses same channels but with different values.
Each sequence is away from the others.
I click on first sequence and i set my chanels values.
Same on 2th and 3th.
I verify my values and i switch between 3 sequences WITHOUT deselect the
last sequence before selecting next.
Sometimes, it copies values from previous selected sequence to the next.
When i see that, I make (repeat) new adjustments, fixtures follows the
order but changes are not recorded. When i reswitch on an other sequence
then come back, values stay wrong.
When i use the "apply for all" button, i have much more problems like this.
Sorry for blurred explainations and bad english...
Thx a lot and Good Luck !
I'm on 8th track. I created 3 sequences that have 1 simple step each
Each sequence uses same channels but with different values.
Each sequence is away from the others.
I click on first sequence and i set my chanels values.
Same on 2th and 3th.
I verify my values and i switch between 3 sequences WITHOUT deselect the
last sequence before selecting next.
Sometimes, it copies values from previous selected sequence to the next.
When i see that, I make (repeat) new adjustments, fixtures follows the
order but changes are not recorded. When i reswitch on an other sequence
then come back, values stay wrong.
When i use the "apply for all" button, i have much more problems like this.
Sorry for blurred explainations and bad english...
Thx a lot and Good Luck !