Q Light Controller+

Hi, i have tried to control qlc+ with my midi-floorboard. i tested
4.6.1, 4.7.1 and 4.7.2 on osx 10.6.

the problem i got was: the virtual console always recives CC-messages,
regardles of the configuration of the midi input channel. notes and
program changes are always ignored (but they are configurable in the
profile editor)

-Chris

hi chris,

i have just spent quite some time with midi and qlc if you can post your workspace, i can take a look at it, maybe i can help you. but this sounds like a hardware or midi problem. when i switch off the midi input in qlc, it does not recieve anything.

regards, sebs

This is not a problem with on/of switching. This is a problem with the "filtering" of midi-messages. For example: if i configure my input-mididevice to recive programm-changes, the virtual console reacts to control-change. i can configure the device also to note-events or control-change, the virtual console always reacts only to control-change