Q Light Controller+

Hi all,

During the warm up part of a night, I will often leave the lights on a chase, whose speed is dictaed using a speed dial which is hooked up to the Traktor beatclock. This works great, however the only problem is is later in the night when I want to manually take over. I have a slider mapped to the same speed dial, that I want to use to manually set the speed of chases etc. Is there anyway way I can quickly turn off the BPM tap without exiting into design mode? I could of course turn it off in Traktor, but then it would turn it off for all chases which I do not want.

Joe

Think I've figured this out. use a two page solo frame, in one have your manual chase speed dial, in the other your BPM speed dial. When you switch to the manual page, the BPM tapped speed dial will no longer be getting MIDI data (Solo Frame MIDI input is only to the active page).