Q Light Controller+

Would it be possible to have a mode added to the Generic RGB fixture where the channels are organized as follows:

-Green
-Red
-Blue

I have several LED strip drivers that are some off brand which I believe are fairly common that use this scheme. It would be nice if this could be included so that it doesn't require a custom fixture definition.

Here is it

Sven,

Thank you for your effort. Perhaps I should have been more clear in my original post. I'm quite familiar with making fixture definitions. I am requesting that this mode be added to the fixture definition that is included with QLC+.

Maybe it would be better to add 5 other modes to the current "Generic RGB" fixture definition, so as to supply all 6 possible orderings of the red/green/blue channels.

Find attached a quick hack edit

Added. Sorry for the big delay