Q Light Controller+

Hi,

The speed dial range selection does not seem to allow for anything but whole number values. Would be really nice if we could have finer control of the ranges? For example - I do not want my chase to go down to 0s as it's just too fast for the lights to handle. I need to be able to set it to 0.3

Joe

Hi Joe,
if you click in the 'decimal' box then the dial will control that.
as you go above 0.99 seconds then it increments into the seconds box.
in teh same way, if you want to control minutes then click in the minutes box.... as you increment below 1 minute the seconds will change (i think???)

Rick

Rick,

Thanks for your reply. That's not quite what I'm looking for. In the input tab in the speed dial properties box, there's a range selection. I really want to be able to edit this to be a decimal so when I'm adjusting the speed of my chase, I can twist a knob to go as high as 2 seconds, but I can't go as low as 0 (0 is just TOO low).

Joe