Q Light Controller+

Hi Massimo, Hi Everyone

I like Qlight very much and i command it with Chataigne.

In shows mode, when i use the space bar, the show run.
With a new hit on the space bar, the show pause.
With a third hit on the space bar, the show continue from where it paused.

With OSC command, /startfunction:1, the show play, pause and restart from the beginning.

All my show is coded but i'd like to have a solution if i'm obliged to put it on pause and to continue it from this state after some minutes by example.

Is there a solution ?

Many thanks in advance
Best regards
Greg.

Hi, what you do in the Show manager is not what you can do in the Virtual Console.
To pause/resume a Show you need to put it in a Cue List widget as a Chaser step with the proper duration.

Hi
My show will normally play from start to end without any stop.
But if i have a problem, i'd like to pause it at any time and continue to play it after resolving the problem.

Is there a way to do that with an OSC command as if i was pressing the space bar ?

Many thanks in avance.
Greg.

There are no external input controls for the show part of QLC+.
If you create a chaser with the same steps, you can pause while it is running.

Hi everyone

First, all my wishes for the New year

I continue to work on the setup of my show many months after my last message here.

I put my show in a chaser and create a cue list.
It works very well with the shortkeys ( i can play, pause, résumé and stop) but not at all with OSC command.

My OSC command are reconized by qlc+ (even in the cue list parameters) but nothing works after.

Someone else here have post a similar message to explain that.

Is there a solution for OSC to command a cue list ?

Many thanks in advance.
Greg.