Q Light Controller+

I am new to this, so struggling a little. Can anyone help fix the problem shown below:

ERROR: In mode <6CH>, channel <Red> cannot act on itself!
ERROR: In mode <6CH>, channel <Green> cannot act on itself!
ERROR: In mode <6CH>, channel <Blue> cannot act on itself!
ERROR: In mode <6CH>, channel <White> cannot act on itself!
ERROR: In mode <6CH>, channel <Dimmer> cannot act on itself!
ERROR: In mode <6CH>, channel <Strobe> cannot act on itself!

You filled in the "Acts on:" column for your channels in the mode editor. The docs clearly state that this should stay empty, it's a rarely used feature for certain inter-dependent channels in some devices.

If you only want to use your fixture in 6 channel mode, you could also use the Fixture Definition of the American DJ Pinspot LED quad DMX.
It uses the same channels in the same order.